Access Control Mode
In this mode, you use normal card access to go in and out of areas. The readers are assigned to do read valid cards and determine if two (2) valid cards are required to enter.
Dual User Area
ARCO Platform enables you to configure an area requiring a minimum of two (2) users present at a given time. The first person to enter will be prompted after valid entry for a dual user so that two (2) people will then be marked in the new dual user area. Any subsequent user can enter, and any user can leave so long as there are at least two (2) people present. When the last two (2) people leave, they will be prompted to both badges to leave.
Navigate to the Hardware Module then to the Profile page.
Create or modify a panel in the Area section.
Under the Advanced tab, Select Dual User.
Dual Supervisor Area
Similar to Dual User Area except at least one user has to be a supervisor.
Navigate to the Hardware Module then to the Profile page.
Create or modify a panel in the Area section.
Under the Advanced tab, Select Dual User.
Entry / Exit Time Attendance
For this mode of operation, when the out reader is used, the user is marked as being out of the building. This mode can also be used for Time Attendance; if the door category is In/Out, then the keypad readers will show the entry or exit message along with the Granted message to feedback to the user they are entering or leaving.
Navigate to the Hardware Module then to the Profile page.
Create or modify a panel in the Door section.
Under the General tab, Select Entry/Exit.
